설치 워크플로

flowchart TD
    accTitle: Apothem install workflow
    accDescr: Top-down flowchart of the apothem install command from CLI invocation through adapter lookup, profile load, adapter install call, native config write, and a follow-up apothem verify check that the operator runs.
    A[apothem install --harness X] --> B[Resolve adapter through registry]
    B --> C[Load and validate profile YAML<br/>before writes]
    C --> D[Adapter.install(profile, project)]
    D --> E[Write native config and support cohorts]
    E --> F[Operator runs: apothem verify --harness X]
    F --> G{All checks pass?}
    G -- yes --> H[Done]
    G -- no --> I[Report failures]

%% provenance: hand-authored %%
%% verified: 2026-07-06 %%
%% cross-reference: this page's Error handling section (back up before replace); /docs/cli-reference/rollback %%
flowchart LR
    accTitle: Apothem backup and rollback lifecycle
    accDescr: At install time each replaced target's prior bytes are captured into the Apothem backup root and the pass is recorded in the harness ledger under a ULID install id. The rollback command selects a recorded install pass by latest or install-id, restores every captured backup from the backup root, and appends a rollback record to the ledger.
    subgraph Install
        direction TB
        I1["Back up existing targets<br/>before replacement"] --> I2["Apothem backup root"]
        I1 --> I3["Ledger install record<br/>ULID install-id"]
    end
    subgraph Rollback
        direction TB
        R1["Select install pass<br/>--last or --install-id ULID"] --> R2["Restore captured backups<br/>from the backup root"]
        R2 --> R3["Append rollback record<br/>to the harness ledger"]
    end
    I2 -.->|captured bytes| R2
    I3 -.->|resolves pass| R1